Subject Re: Report designer problems From Robbie Nott <robnott@mweb.co.za> Date Thu, 4 Apr 2024 11:39:45 +0200 Newsgroups dbase.getting-started On 4/2/2024 11:34 PM, Charlie wrote: > I have run into this before and I can't remember how or if I was able to solve it.  I have a report with 8 fields across and smaller font to accommodate.  I originally had 6 fields but I am trying to add two.  I am trying to adjust the top of the data (not heading as that is set at zero. )  im in inches for metric.  I am truing to position the top at .22 and some work ok, the two new fields especially will not go to the correct top.  And if you try to physically move them, they slide all over the place.  Is there a fix for this?  Thanks..  Charlie Hi Charlie Make sure the Variable Height is off for all 8 fields Set the sequence of the 8 in the code editor so thet they get drawn in order from left to right, top to bottom. -- This email has been checked for viruses by AVG antivirus software. www.avg.com