Subject Re: ok button missing in datecalendar.cc From Ken Mayer <dbase@nospam.goldenstag.net> Date Tue, 7 Nov 2023 05:09:08 -0800 Newsgroups dbase.getting-started On 11/6/2023 9:48 PM, Charlie wrote: > I have been using a completely blank form and when unsuccessful I delete it and try again.  I just followed your instructions by completely shutting down dbase after deleting the test form.  Then shutting it down again after saving the set procedure statement, then going from there.  ill upload the results.  And yes the little calendar icon is missing when i open the form but appears when i hoover over it.  The select button under the calendar is missing as shown in the png file attached to this message.  I did not get an error message this time or the last time. > > I am using my laptop for this.  It works well using my desktop.  I will try this form I created on my desktop tomorrow morning but I believe I have tried that before with no luck. > > Seems like there is something happening on my laptop which is causing this. You didn't explain that it was on the calendar itself that you were having problems. At least I didn't get that from your description. I cannot reproduce it, however. I don't know why the calendar form isn't quite tall enough on your computer to show that button. Ken -- *Ken Mayer* Ken's dBASE Page: http://www.goldenstag.net/dbase The dUFLP: http://www.goldenstag.net/dbase/index.htm#duflp dBASE Books: http://www.goldenstag.net/dbase/Books/dBASEBooks.htm dBASE Tutorial: http://www.goldenstag.net/dbase/Tutorial/00_Preface.htm dBASE Web Tutorial: http://www.goldenstag.net/dbase/WebTutorial/00_Menu.htm dBASE DOS to Windows Tutorial: http://www.goldenstag.net/dbase/DtoWTutorial/00_Menu.htm