Subject Re: SpeedTip followup From Ken Mayer <dbase@nospam.goldenstag.net> Date Wed, 22 Feb 2023 12:53:50 -0800 Newsgroups dbase.getting-started On 2/22/2023 10:42 AM, Lee Grant wrote: > Ken, > > Can't explain it. I just did a "? Set("EXACT")" check, ran it, clicked > one to change from "LightGrey" to "Fuchsia", "Fuchsia" to "Lightgrey", > and tried to click it again, and there was no visible change, and it > stayed on the "Lightgrey" for the remainder of my clicks. Pic below to > show where I was after the "Lightgrey" was in effect. > > I don't know why the difference. I can understand that Tom's > hardware/software emulation of a Windows environment could cause a > possible issue, but not mine.  I guess my version of dBASE 2019 isn't as > good as yours. :) > Re: last bit -- honestly, I have the same version as everyone else, so I have no idea ... I just double-checked with SET EXACT, set it ON, got the expected behavior, because the two text strings don't match, set it (set exact, that is) OFF and it works, toggling back and forth. Ken -- *Ken Mayer* Ken's dBASE Page: http://www.goldenstag.net/dbase The dUFLP: http://www.goldenstag.net/dbase/index.htm#duflp dBASE Books: http://www.goldenstag.net/dbase/Books/dBASEBooks.htm dBASE Tutorial: http://www.goldenstag.net/dbase/Tutorial/00_Preface.htm dBASE Web Tutorial: http://www.goldenstag.net/dbase/WebTutorial/00_Menu.htm dBASE DOS to Windows Tutorial: http://www.goldenstag.net/dbase/DtoWTutorial/00_Menu.htm