Subject |
Re: CODE WORKS IN NATIVE DBASE, BUT NOT COMPILED DBASE |
From |
ED <ED@UNIV-COMPUTERS.COM> |
Date |
Fri, 02 Dec 2022 16:29:57 -0500 |
Newsgroups |
dbase.getting-started |
Richard Wrote:
> Try it with lineno() instead of line()
>
> and please turn off solid caps
>
> On Fri, 02 Dec 2022 14:28:42 -0500, ED <ED@UNIV-COMPUTERS.COM> wrote:
>
> >Andy Taylor Wrote:
> >i am trying to use upper/lower case, takes while to remember. Sorry
i just sent the message to a WFM screen and that woried....
> >> On 27/11/2022 03:34, ED FURCHE wrote:
> >> > ED FURCHE Wrote:
> >> >
> >> >> CODE WORKS IN NATIVE DBASE, BUT NOT COMPILED DBASE
> >> >>
> >> >> IT WONT CREATE THE FILE TO SEND TO THE REPORTING (CRYSTAL)
> >> >>
> >> >> THIS CODE HAS WORDKED FOR YEARS, SUDDENLY STOPPED.
> >> >
> >>
> >> At what line of your submitted code (in dbaseCode.docx) does the program
> >> bug out?
> >>
> >> You say it won't create the file but at what point in that code do you
> >> think it creates the file?
> >>
> >> If you don't already know I suggest you insert like like the following
> >> into your existing code.
> >>
> >> ? "I got to "+line()
> >>
> >> At almost every line where you think it might choke.
> >>
> >> Run it in "native" dbase and check that it runs ok
> >>
> >> Then compile it (I assume you mean create an exe)
> >>
> >> Run it again and tell us where it chokes (and only show us that code).
> >>
> >> Andy
> >
> >THAT LINE DOESNT WORK. I TRIED IT. WISH IT DID...
|
|