Subject Re: CODE WORKS IN NATIVE DBASE, BUT NOT COMPILED DBASE
From ED <ED@UNIV-COMPUTERS.COM>
Date Fri, 02 Dec 2022 14:28:42 -0500
Newsgroups dbase.getting-started

Andy Taylor Wrote:

> On 27/11/2022 03:34, ED FURCHE wrote:
> > ED FURCHE Wrote:
> >
> >> CODE WORKS IN NATIVE DBASE,  BUT NOT COMPILED DBASE
> >>
> >> IT WONT CREATE THE FILE TO SEND TO THE REPORTING (CRYSTAL)
> >>
> >> THIS CODE HAS WORDKED FOR YEARS, SUDDENLY STOPPED.
> >
>
> At what line of your submitted code (in dbaseCode.docx) does the program
> bug out?
>
> You say it won't create the file but at what point in that code do you
> think it creates the file?
>
> If you don't already know I suggest you insert like like the following
> into your existing code.
>
> ? "I got to "+line()
>
> At almost every line where you think it might choke.
>
> Run it in "native" dbase and check that it runs ok
>
> Then compile it (I assume you mean create an exe)
>
> Run it again and tell us where it chokes (and only show us that code).
>
> Andy

THAT LINE DOESNT WORK.  I TRIED IT.   WISH IT DID...