Subject Re: Form called in .prg is not getting executed From Milind Nighojkar <milinigh@yahoo.com> Date Tue, 02 Nov 2021 14:07:19 -0400 Newsgroups dbase.getting-started Hello Ken, Thanks it worked... Regards Milind Nighojkar Ken Mayer Wrote: > On 10/31/2021 9:39 PM, Milind Nighojkar wrote: > > Facing Issue in executing form when called in a program. > > > > Scenerio : > > ......above code lines > > do t_form.wfm > > .....below code lines > > > > Issue : expecting to exute (......above code lines) and then executing t_form as inputs in the form are used in .....below code lines. It skips and tries to execute (.....below code lines..) > > > > Anything I am missing? > > > > however if I call t_form say in t_form.prg which has code lines > > do t_form.wfm > > > > it executes > > If the form is an "MDI" form, then any code that follows the command: > > do t_form.wfm > > Is also executed, which means that for example if you release the form, > the form may appear, but it will be released. Execution of the program > doesn't stop. > > If you instead use: > > do t_form.wfm with true > > The form will be treated as a modal form, the program will stop until > the form is closed, then any code after that will be executed. > > Ken > > -- > *Ken Mayer* > Ken's dBASE Page: http://www.goldenstag.net/dbase > The dUFLP: http://www.goldenstag.net/dbase/index.htm#duflp > dBASE Books: http://www.goldenstag.net/dbase/Books/dBASEBooks.htm > dBASE Tutorial: http://www.goldenstag.net/dbase/Tutorial/00_Preface.htm > dBASE Web Tutorial: http://www.goldenstag.net/dbase/WebTutorial/00_Menu.htm