Subject Re: Changing 2019 address From Mervyn Bick <invalid@invalid.invalid> Date Sun, 10 Oct 2021 10:33:31 +0200 Newsgroups dbase.getting-started On 2021/10/10 00:20, Bob McKinney wrote: > Hi Ken:  I repaired the BMCustom Source Aliase address as you suggested.  Same results. > I created a new form w/2019 just in case ther was something different. (see code below). It's a silly question but did you create a folder for BMCutom on the new computer and did you copy the source code in the BMCustom folder on the old computer to the folder on the new computer? If you copied any compiled files (i.e any *.*o files EXCEPT *.ico which are icons) to the new computer you should delete them. Make quite sure your Source Alias is correctly defined on the new computer.  In the main menu across the top of dBASE select "Properties" then "Desktop Properties" and then click on the "Source Alias" tab.  Use the little left and right arrow buttons on right of the tabs to scroll if the "Source Alias" tab isn't visible.  Scroll down the list of Aliases and select BMCustom.  Make sure the "Path" field contains the correct path.  If it doesn't, click on the little "pencil" button and navigate to the correct folder.  Click the "Select Folder" button. Go back to your test form and see if it will run. Mervyn.