Subject Re: IDE halts for 1 minute when exiting app From Ken Mayer, dBase, LLC <kmayer@dbasellc.com> Date Tue, 31 Aug 2021 09:25:54 -0700 Newsgroups dbase.getting-started On 8/31/2021 9:02 AM, Paolo Baranzoni Esseduesoft wrote: > I'm trying to build an mdi app following the dBase tutorial. > But when i exit the app and go back to dBase IDE and try to open a file > in the source code editor (or design) then IDE halts for almost a minute > waiting for "i dont know what" and finally opens the source code editor. > I use dBase2019 on Windows10 pro 64bit. > Attached the four files (but they are almost the same as the tutorial) > Is there something wrong? > Thanks One thing I have noticed with my computer is that with a very large (6TB) hard drive, and a startup drive that is smaller, when opening dBASE when it was working with code/data on the large hard drive, the drive sometimes goes to sleep. It takes a bit for it to "wake up" and then it loads, and all is well. I don't know of course if that is the issue for you. But it is a bit annoying for me. (However, this is not a dBASE issue if that's the case, it's just the drive sleeping and then waking up ...) Ken -- *Ken Mayer*, dBase, LLC Ken's dBASE Page: http://www.goldenstag.net/dbase The dUFLP: http://www.goldenstag.net/dbase/index.htm#duflp dBASE Books: http://www.goldenstag.net/dbase/Books/dBASEBooks.htm dBASE Tutorial: http://www.goldenstag.net/dbase/Tutorial/00_Preface.htm dBASE Web Tutorial: http://www.goldenstag.net/dbase/WebTutorial/00_Menu.htm