Subject Re: BLOB File not found From Mervyn Bick <invalid@invalid.invalid> Date Wed, 19 May 2021 21:41:15 +0200 Newsgroups dbase.getting-started On 2021/05/19 15:16, Leif wrote: > I checked the .dbf files and they all seems to both memo and image they should. It is in the report file (.rep) it comes up, saying: > -Open without blob file > -Fail Open > -Empty all blob fields > I do "Open without blob file" which I then have to do a 11 times and therafter choose printer comes up. After choosing the printer I have to do the same 11 times again the the print out comes OK. If you can open the table without problems in the IDE but it can't find the .dbt file for the report are you quite sure that the report is looking at the same file? You could try creating a new report but instead of using the datamodref simply drag the table from the Navigator onto the report. Mervyn.