Subject Re: PLUS1231Runtime-b2591 From Ken Mayer <dbase@nospam.goldenstag.net> Date Thu, 10 Sep 2020 08:57:59 -0700 Newsgroups dbase.getting-started On 9/10/2020 7:42 AM, Cornelius wrote: > Akshat Kapoor Wrote: > >> On 10.09.2020 18:47, Cornelius wrote: >>> Hi there. I did a upgrade from dbase 6.1 November 18. dbase 12 >>> >>> I converted programs and developed and installed then successfully using the above runtime installer. >>> With last installation of same program all the numeric points turned from full stop to a comma. I did installation on one pc and that was correct and next day on 2nd pc it was wrong. I tried again with no luck. I hope someone can explain this to me! >> >> Good Evening Cornelius, >> >> Please check the regional settings of the computer creating problems. >> >> Was dbase/runtime ever installed on that machine. >> An old ini file could be spoiling things. >> >> Regards >> Akshat >> > Hi Akshat, > Thanks for responding. > This is a new machine with first installation. > The pc are in a town 250 klm from here. I  did set up anew one and installed program and runtime with same result. > > > I will check the regional settings tomorrow. I am in South Africa and time to go home. Enjoy your evening. You may wish to take a look in the OLH, you can set the default settings for your application in a setup routine for your application (that would be run before starting menus or whatever and should affect everything until the application is closed): SET POINT TO [<expC>] There are other regional settings as well, such as dates and so on that you may want to look at. Ken -- *Ken Mayer* Ken's dBASE Page: http://www.goldenstag.net/dbase The dUFLP: http://www.goldenstag.net/dbase/index.htm#duflp dBASE Books: http://www.goldenstag.net/dbase/Books/dBASEBooks.htm dBASE Tutorial: http://www.goldenstag.net/dbase/Tutorial/00_Preface.htm