Subject Re: Printing problem resolved From Charlie <tm@tc.com> Date Wed, 22 Jul 2020 11:00:31 -0400 Newsgroups dbase.getting-started Hey thanks. Actually it was something along that line.  But sort of stupid on our part.  I didn't realize it was hard wired into the printer which is a wireless printer.  It now works fine un-wired.  Thanks again for the suggestions. Lee Grant Wrote: > Charlie, > > Just as a shot in the dark guess, make sure the networked printer driver > isn't setup to auto eject a blank page when the printing was finished. > Since it's obvious now, that it printed on the desktop without a > problem, the problem now lies in the network and it's setup issues...as > a guess of course. :) > > Lee > > > On 7/21/2020 4:19 PM, Charlie wrote: > > Thanks to all for the help. > > > > We tried Mervyn's solution on the network machine and it still printed a blank copy.  Then I tried printing to the printer directly from my laptop and the result was no blank page.  Either I didn't configure the set up file correctly or possibly there is an issue elsewhere.  I'll do some more work on this tomorrow.  once again thanks for the suggestions..  I'll try them all until I figure this out. > > > > Mervyn Bick Wrote: > > > >> On 2020-07-17 05:49, Charlie wrote: > >>> Hi Mervyn > >>> > >>> I have 11 by 8.5 inches in pagetmplate position.  is that what you mean? > >>> > >> > >> Are you using 11 X 8.5 paper? > >> > >> Is the printer driver also set to 11 X 8.5 paper.  If the printer is set > >> to, say, A4 paper you would get the extra blank sheet for each page. > >> > >> Mervyn. > >> > > >