Subject |
Results pane shows nothing |
From |
Pieter van Heerden <psvh@mweb.co.za> |
Date |
Sat, 13 Oct 2018 02:51:54 -0400 |
Newsgroups |
dbase.getting-started |
I have recently re-installed dBase 11 on my laptop (Windows 10) and have seen the following.
Commands typed into the command window that should show a result in the result pane does not show anything. Same for print output (?) command lines in an application. Nothing is seen. I have looked for a setup setting that could result in this, but have seen nothing.
Did anyone have a similar experience, and how was it solved?
|
|