Subject Re: 11.3 will not run From Andy Taylor <andy.taylor@which.net> Date Mon, 16 Apr 2018 18:49:28 -0400 Newsgroups dbase.getting-started Tom, This is NOT a common problem. Try uninstalling 11.3 and the BDE. Once that is done inspect the registry (use regedit) for any dBase or Borland entries anywhere and make sure they and the folders are deleted. Only then will you know that it has totally gone. Reboot and reinstall 11.3 from scratch. Let us know. Andy > Andy Taylor Wrote: > > > Tom, > > > > Have you tried deleting the Plus.ini file that you will find in C:\Users\YourName\AppData\Local\dBASE\Plus11\Bin > >  and then restarting dBase? > > > > Are you really also saying that you can open dBASE 11.3 when your computer is running under windows SAFE mode > >  but not when it's running normally?  What version of windows are you running? > > Do you have have v9 installed? If so, does that still run? > > > > Andy > > > > > I have installed new version 11.3.  It will not run.  I don't get an error or anything.  Same computer had version 9 running without issues.  dBase tech support have tried to help, but still no solution.  It will run in safe mode.  Any suggestions appreciated. > > > "Have you tried deleting the Plus.ini file that you will find in C:\Users\YourName\AppData\Local\dBASE\Plus11\Bin > >  and then restarting dBase?"  tried this, but still same result > > I can run 11.3 in safe mode.  But when not in safe mode it will not run.  I am running Windows 10.   > > I had version 9 installed and it still ran after installing 11.3.  I have since removed it, thinking that might be causing a problem.  But, still no luck getting 11.3 to run. >