Subject Re: can open EXE twice
From Ken Mayer <dbase@nospam.goldenstag.net>
Date Fri, 13 Apr 2018 07:14:18 -0700
Newsgroups dbase.getting-started

On 4/13/2018 6:53 AM, ed furche wrote:
> I cant open 2 instances of my EXE.  I get "Insufficient Memory on 2nd one.  If I run IDE code, it points to lines of code where i try to copy a dbf structure to the local drive.  I took some out,  but not sure if this is the right approach.
> If you look at my resources,  I am only using about 5-10% of memory.

This is a BDE thing. Take a look at your BDE settings using the BDE
Administrator.

Check the newsgroups -- there are several messages about these settings
with suggestions for what to change.

Ken


--
*Ken Mayer*
Ken's dBASE Page: http://www.goldenstag.net/dbase
The dUFLP: http://www.goldenstag.net/dbase/index.htm#duflp
dBASE Books: http://www.goldenstag.net/dbase/Books/dBASEBooks.htm
dBASE Tutorial: http://www.goldenstag.net/dbase/Tutorial/00_Preface.htm