| Subject | Re: _pdriver does not work |
| From | Yiannis H. Economides <yianeco@cytanet.com.cy> |
| Date | Tue, 20 Feb 2018 11:58:49 -0500 |
| Newsgroups | dbase.getting-started |
Peter, Using CHOOSEPRINTER() and _pdriver you can get the exact string that is required to use in your code. No matter if it is dbase 2.62, 8,10 or 11 it is the same method if you want to use ?, ?? commands to prepare a report. It works all the time but it is time consuming and not easy to check the final product. I use a lot crystal reports in my applications also. Regards Yiannis Peter Berglas Wrote: > Ken Mayer Wrote: > > > On 1/31/2018 7:04 AM, Peter Berglas wrote: > > > I have sent prior requests for help in this matter, but no matter what I try, I can't get _pdriver to change. Using Windows 10. Please take a look at the file below. In dBase Plus 11, _pdriver does not send the streaming to the appropriate paper location in my Okidata printer. In Visual dBase 7.01, I have no problem. I have been using vdb for years and upgraded to Plus 11 early in 2017. This is the only problem I am having and I cannot figure out what to do. > > > I have even tried a small batch file that changes the Windows default printer, but this does not come into effect until I close dBase and then restart it. > > > I have tried _app.printer also to no avail. > > > Please note that these are not reports, but streaming. > > > I look forward to some help. > > > > I hate to tell you this, but the old streaming code for printing was > > written for DOS, and doesn't translate well to Windows. If you cannot > > get _PDRIVER to work (and most of us are not really going to try), you > > are going to need to learn to use the dBASE report engine ... it's not > > that bad, there is some help in my tutorial (see below), and I have > > written a book on dBASE reports that can be helpful. > > > > Ken > > > > -- > > *Ken Mayer* > > Ken's dBASE Page: http://www.goldenstag.net/dbase > > The dUFLP: http://www.goldenstag.net/dbase/index.htm#duflp > > dBASE Books: http://www.goldenstag.net/dbase/Books/dBASEBooks.htm > > dBASE Tutorial: http://www.goldenstag.net/dbase/Tutorial/00_Preface.htm > > Hi Ken, > I hate to tell you this, but even though the old streaming code for printing may have been written for DOS, and may not translate well to Windows, with a bit of work I was able to accomplish the transition without rewriting all my streaming code. Most of us might not try, but I did. > I used : _app.printer.printerName="Okipage 10ex Manual Feed" > My problem was that I was using _app.printer.printerName="WINSPOOL,Okipage 10ex Manual Feed" > By trail and error using the Command window, I found out that the "WINSPOOL" should not be included. I think this was mentioned elsewhere. Did not need chooseprinter(). > I hope this helps others too. > Peter > | |