Subject |
Re: allowing user to change or add an alias |
From |
Charlie <tm@tc.com> |
Date |
Wed, 21 Jun 2017 16:13:53 -0400 |
Newsgroups |
dbase.getting-started |
OK tried it but not as fortunate as you Mervyn. One of the wonders of the world! :)
Mervyn Bick Wrote:
> On 2017-06-20 11:30 PM, Charlie wrote:
> > Hi Mervyn...
> >
> > Are you saying that previous (10.3.1) versions don't work? I noticed that on the dbase page 10.3.1 is the latest for dbase. Runtime seems to match it at 10.3.1. I don't think it did before!!! Not sure. Could have they added that due to problems?
>
> No, I didn't say that BDEAlias.cc doesn't work with dBASE 10.3.1. I
> said that BDEAlias.cc didn't work for me with dBASE 11.2.1 although i
> did work for Ken.
>
> I found that after I'd installed dBASE 11.3 that BDEALias worked as
> expected. I then tried my little program in dBASE 10.3.1 and it failed.
>
> After I had reinstalled dBASE 10.3.1 BDEAlias worked. Bingo!
>
> Went back to dBASE 11.3 and the program hangs dBASE. Another reinstall
> of dBASE 11.3 and all is well again. I guess installing dBASE and the
> BDE sets some flag that ties the BDE to the version of dBASE most
> recently installed.
>
> I'm always reluctant to suggest reinstalling software but in this case
> it is probably justified. Reinstalling dBASE 10.3.1 oveeeer you
> existing installation should only take a few minutes and it shouldn#t
> upset anything.
>
> Mervyn.
>
|
|