Subject Re: lost navigator From Kurt <woodrep@gmail.com> Date Sat, 12 Jul 2014 01:33:12 -0400 Newsgroups dbase.getting-started Attachment(s) Plus.ini - Notepad.pdf Same problem here, no success with your solution and no scrollbars. Does it have anything to do with a previous Plus version being installed? The Navigator and command window are there when plus starts. After running a wfm and closing it they have gone. To get them back I select Desktop properties, click OK and both are back on the Desktop. David Ball Wrote: > Hi Floyd > > The Navigator window may be there, but it may be off-screen > somewhere. > > Are your scrollbars visible? If so, try scrolling to the far > ends to see if the navigator is there. > > The best way would be to locate your Plus.ini file and reset > it from there. > Run ? home() in the command window to locate where plus.exe > is > Close dBASE > Go to the folder you found above > Open plus.ini with notepad > Locate the [Navigator] section > Look for the Position line > The first 2 numbers are the coordinates for the left top > corner of the window. For starters, these can be set to 0. > The next 2 numbers are the width and height of the window, > if I recall correctly. Set each to 500. Once the box has > been located, then you can adjust the size to what you want. > So you should have: > Position=0 0 500 500 > Save and close the plus.ini file > Open dBASE > If it\'s not there, check your scrollbars again and move to > the top left corner as far as possible. Check your View and > Window menus if necessary. > > Please let us know how it goes. > > Thanks > David Ball > www.dBASEHost.com > > > \"floyd\" <flodor@symptico.ca> wrote in message > news:SadyiXuZPHA.2128@ip-0AF54737... > >I have lost the navigator from dbase 2.7. It was available > >last night when I exited from dbase but this morning when I > >opened the program the navigator was no longer there. I > >have uninstalled the program and re- installed but to no > >avail. It is listed as being available but clicking on it > >doesn\'t bring it up on the screen. Command screen is > >available. Anyone ever have this problem? Any help would be > >appreciated. Thanks > >